Wiring:
Heater cartridge from V6 hotend
connect to the
“H
otend
” +
-
Thermistor from V6 hotend
connect to the
“
Hotend thermistor
“
Left hotend fan (4010 fan)
connect to the “Always on power” red+ black
-
Front print fan (5015 blower fan)
connect to the “Layer fan”
red+ black-
Connect the new extruder motor to the
“E
motor
”
Summary of Contents for BMG CR-10 PrintHead
Page 9: ...13 Use two M3x10 screws to attach the fan duct to the print head...
Page 11: ...16 Route the front print fan 5015 fan wires as shown in the picture...
Page 14: ...20 Wire harness management demonstration...
Page 17: ...If you want lower the BL touch please using the springs or washers in the BL touch kit...
