Auto bed leveling sensor installation
1.
M8 Proximity Sensor (5V)
、
Fix the proximity sensor using the PINDA_mounting_bracket and two M3x10 screws.
Make sure the sensor is 1mm higher than the nozzle.
If you want using this sensor you need the PEI film spring steel sheet (or PEI powder coating) as your
printing surface. Shopping link:
https://www.aliexpress.com/item/33006152423.html
Other type of print surfaces such as glasses Flexible Magnetic Sheet will not working.
Summary of Contents for BMG CR-10 PrintHead
Page 9: ...13 Use two M3x10 screws to attach the fan duct to the print head...
Page 11: ...16 Route the front print fan 5015 fan wires as shown in the picture...
Page 14: ...20 Wire harness management demonstration...
Page 17: ...If you want lower the BL touch please using the springs or washers in the BL touch kit...
