** Adding the Damper Tubes to the Chassis assembly **
Snap the assembled & lubed damper tubes on the respective points as
shown in the diagram to the right. You will find it easier to snap on the
centered, smaller 2-56 ball studs first, then pop the outer, larger 4-40 ballcups
6
CRC
Tube
Lube
5
35
Completed Tube
5 - Add CRC Tube Lube [35] to each slot on the delrin plunger [33].
Build the tube and be sure it has smooth, damped action.
***
: fill only the slots, not the entire aluminum tube [34]. ***
Note
Bag 5
Damper Tubes
Bag 6
Molded
ABP Braces
Adjustable Battery Position
36
4-40 x 1/4”
Flat Head
22
Your new Gen-XL continues to have CRC’s Adjustable Battery Positioning (ABP).
This adjustability gives the car a wide range of handling possibilities. We
recommend running the battery to the rear for the most steering entering the corner.
However, if the car is over aggressive on entry or tries to flip, moving the battery
forward will smooth it out.
Using the 4-40 x 1/4” flat head screws [22], push the screws through the chassis [6]
and then thread them into the plastic ABP braces [36] as shown in the diagram.
ABP - Rearward
36
22
ABP - Forward
36
22
ABP - Rearward
ABP - Forward
