Left Side Plate
Graphite X-brace
Graphite
Top Plate
1 - Install the black 2-56 ballstuds [15] into the graphite top plate [16]. These steel balls thread into the
graphite, no nut is needed. Be sure to start them straight and square and turn them in slowly so they do
not strip or break.
2 - Push the red ballstud [17] through the graphite plate [16]. Use a red locknut [9] to secure it. Attach the
assembled top plate to the Motor plate [19] using 3 1/4” button head screws [21].
3 - Install the Graphite X-brace [18] to the back of the Motor
Plate [19] and left side pod plate [20]. Use 4 1/4” button head
screws [21] to attach the graphite piece to the pod plates.
4 - Install the completed rear pod assembly to the rear bottom
plate using 4 1/4” flat head screws [22]. Keep an eye on these
screws during the first few runs of your car. They tend to
loosen until they take a “set” and then they WILL stay tight.
*Note - Although we are using steel screws in this kit, you may
opt to use optional aluminum screws in the future. We do NOT
recommend using thread lock in any aluminum to aluminum
application. The best way to keep these tight is by keeping a
close watch on their tightness after your first few runs.
In time, the screw will naturally “seat” and stay tight.
16
18
19
Bag 3
4-40 x 1/4”
Button Head
4-40 x 1/4”
Flat Head
Red Alum
4-40 Ballstud
2-56 Steel
Ballstud - Black
Rear X-Pod
3
15
17
21
Red Locknut
9
22
18
21
Motor Plate
20
15
9
16
17
20
19
21
22
