T008-0132
T008-0131
FOIL USER MANUAL
Insert the two Socket head torx screws
M6x20mm and the two washers in the
holes without tightening. Proceed to
tighten the screws.
FOIL BOARD
4x
Foil Board
[M6x18] PHILIPS
Washer
[M6]
4x
FOIL STRAPS
6x
Footstrap Foil
[M6x14] PHILIPS
Washer
[M6]
6x
4x
FUSELAGE
2x
Fuselage
[M6x20] TORX
Washer
[M6] ø6.2 x ø9.9 x 1
2x
Insert 1 piece flat head screw M6x16mm in the
rear hole, 2 pieces M6x20mm in the others.
Proceed to tighten the screws.
Remove wooden plate protection and screws
holding the wood.
We suggest to turn the foil board upside down,
so that the bottom of the foil board is facing you
and lay it flat on a carpet or soft surface.
Then, place the foil mast mounting plate
overlooking the inserts on the board and select
desired foil position.
Place 4x M6 washers over the holes on the foil
mast mounting plate and place screws into the
hole. Tighten fully.
After the first session,
please check all screws,
if they are loose and
tighten all loose screws.
We strongly suggest to
check all screws are
tightened properly
before each session.
FRONT WING FREERACE 558
1x
Front wing
[M6x16] HEXALOBULAR
Front wing
[M6x20] HEXALOBULAR
2x
Insert the flat head screws M6x20mm in the
corresponding hole without tightening.
Proceed to tighten the screws.
FRONT WING FREEIDE 550
Front wing
[M6x20] HEXALOBULAR
3x
Insert the flat head screws
M6x16mm in the corresponding
hole without tightening. Proceed
to tighten the screws.
Always keep the threaded holes
clean and lubricate often by using
Lithium grease to avoid and
prevent oxidation and corrosion
due to sea water.
STABILIZER
Stabilizer
[M6x16]
HEXALOBULAR
2x
GREA
SE
GREA
SE
GREA
SE
GREA
SE
