Crane Barnes SGV 2 HP, Service Manual, Page: 27 / 32

27
Valute, Shredding Ring, & Cutter
Next install shredding ring into the volute
body with the use of an arbor press.
Insert throat into body with three fl at head
Allen screws, use green loctite on threads.
Lubricate square ring and place on groove in bottom seal plate. Place volute on seal plate being careful
not to damage square ring. Place washers and nuts on studs and tighten equally to 11 ft/lbs.
NOTE: Discharge must line up with notch in motor housing.
Screw radial cutter on shaft turning clockwise, holding motor shaft stationary with a screwdriver. Radial
cutter should be fl ush with shredding ring on suction side to within ±.020. Replace washer and screw and
tighten. Use green loctite on threads.
56
59
58
57