FLIP TARP
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com - Manual no. MFT002-EN-ED07 – date 02/05/2017
Page 24
+
−
CONTROL UNIT ELECTRIC CONTACTS
Fig. 19
The control unit has 4 connection elements, 2 for the motor
and 2 for the battery.
The connection must be carried out with two electric cables, one
of which is directed to the tarpaulin motor, while the other one to the
power supply circuit, where it is essential to connect the
fuse.
CONNECTION DIAGRAM
– CONNECTION:
Staple the FASTON cables with eyelet on
the cable whose insulation has already
been removed.
Insert the Faston cables as shown in the
figure and tighten the nuts.
A pre-perforated metal support is supplied to secure the control unit to the vehicle and is used to quickly mount
it with just four screws.
REAR SUPPORT
CONTROL UNIT WITH FASTENING SUPPORTS
OPERATION
Turn SWITCH 1 to the position shown in the figure, the container is either uncovered or covered.
After the step, IMMEDIATELY RELEASE THE SWITCH to prevent the motor from overheating or being
permanently damaged.
The motor is protected during movements.
When the tarpaulin system is opened or closed, the RED LIGHT must not come on.
