6
Screws
Carry
Handle
Powerhead
Assembly
Caster/Caster Foot Assembly (Fig. C)
1. Remove the Powerhead Assembly from the Dust Drum
and set aside.
2. Turn the Dust Drum upside down on the floor.
3. Insert the Caster Feet into the bottom of Drum, as
shown (4 places).
4. Push on the Caster Foot until the Foot is flush with
bottom of the Dust Drum.
5. Insert the Caster Stem into the Socket of the Caster
Foot, as shown (4 places).
6. Push on the Caster until the Ball on the Caster Stem
is inserted all the way into the Socket. You will hear
the Ball snap into the Socket and the Caster will swivel
easily when positioning is correct.
7. Turn the Drum upright.
Caster
Caster Stem
Caster Ball
Caster
Foot
Pin
Hole
Dust
Drum
Carry Handle Assembly (Fig. E)
1. Place the Carry Handle on the Wet/Dry Vac Powerhead
Assembly.
2. Tighten both Screws to assemble the Carry Handle on
the Powerhead Assembly.
20 Gallon (75 Liters) Shown
Hose Clip Assembly (Fig. D)
(Models CMXEVBE175940, CMXEVBE175950,
CMXEVBE175960)
1. Align the Hose Clips in the recessed areas on the
Powerhead Assembly.
2. Insert Screw and tighten to fasten the Hose Clip to the
Powerhead Assembly.
Screw
Hose
Clip
Powerhead
Assembly
INSTALLATION
Fig. D
Fig. C
Fig. E
SP7075-1 6, 9, 12, 16, 20 Gallon 2019.indb 6
2/22/19 10:31 AM
