English
6
it into the tool until the battery pack is firmly seated in the
tool and does not disengage.
To remove the battery pack from the tool, press the battery
pack release button
9
and firmly pull the battery pack out
of the tool. Insert it into the charger as described in the
charger section of this manual.
8
9
Fig. B
Task Light Placement (Fig. C, D)
The task light can be used one of three ways.
• On a level surface as shown in Figure C.
• Wall mounted using the keyhole slots
6
located on the
bottom of the task light as shown in Figure D. Refer to
Keyhole Slots
for further instruction.
• The light can be handheld.
Fig. C
Keyhole Slots (Fig. D)
Use the back of the keyhole slots
6
on the mounting
base as a template for the location of the mounting
screws. Mount the task light securely using drywall screws
(purchased separately) at least 1” (25.4 mm) long, with a
screw head diameter of 0.28–0.35” (7–9 mm), screwed
into wood to an optimal depth leaving approximately
7/32” (5.5 mm) of the screw exposed. Align the slots on the
mounting base with the exposed screws and fully engage
them in the slots.
Fig. D
6
Light Levels (Fig. A)
The task light has 2 brightness levels. Continue to press the
On/Off switch
1
to cycle from OFF-HI-LO brightnesses.
On/Off Switch (Fig. A)
CAUTION: Do not stare into task light lens.
Serious
eye injury could result.
To turn the task light on, press the On/Off switch
1
.
To turn the task light off, press the On/Off switch until the
light goes out.
Pivoting the Light Housing (Fig. E)
The task light housing
3
can be pivoted to different
positions within the 360° pivot range.
1. To pivot the task light housing first loosen the pivot
knobs
2
.
2. Rotate the task light housing to your desired position.
Tighten the pivot knobs.
.
Fig. E
2
3
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and before making any
adjustments or removing/installing attachments
or accessories.
An accidental start up can
cause injury.
