ASSEMBLY
10
Figure 1 shows the snowthrower in the shipping position.
Figure 2 shows the snowthrower completely assembled.
Reference to right and left hand side of the snowthrower is
from the operator’s position at the handle.
UNPACKING
1.
The snowthrower is shown in the shipping position
(see Figure 1).
2.
Cut down all four corners of the carton and lay the
side panels flat.
3.
Locate all parts that are packed separately and
remove from the carton.
4.
Remove and discard the packing material from
around the snowthrower.
NOTE: Set the fuel stabilizer aside until adding
gasoline to the fuel tank. We recommend that fuel
stabilizer is added to the fuel each time that gasoline
is added to the fuel tank.
5.
Remove the packing material from the handle assembly.
6.
Cut ties securing the clutch control cables to the lower
handle.
NOTE: If the cables have become disconnected from the
clutch levers, reinstall the cables as shown in Figure 3.
Figure 1
Figure 2
Auger Drive
Clutch Lever
Traction Drive
Clutch Lever
Snow Chute
Deflector
Height Adjust
Skid
Auger
Housing
Remote Deflector
Control
Speed Select
Lever
Toolbox
Figure 3
Drive Lever
Cable
”Z” Fitting
Not
for
Reproduction
