TOOLS REQUIRED FOR ASSEMBLY
1 – Knife
CONTENTS OF SHIPPING CARTON
1 – Snowthrower
1 – Container of Fuel Stabilizer (Located in Parts Bag)
1 – Container of Oil
1 – Electric Starter Cord
WARNING: Always wear safety glasses or eye shields
while assembling snowthrower.
Figure 2 shows the snowthrower in the shipping position.
Reference to the right and left hand side of the snowthrower is
from the operator’s position at the handle.
UNPACKING
1. Locate and remove container of oil.
2. Locate all parts packed separately and remove from the carton.
NOTE: Set the fuel stabilizer aside until adding gasoline to the
fuel tank. We recommend that fuel stabilizer be added to the fuel
each time that gasoline is added to the fuel tank.
3. Remove and discard the packing material from around the
snowthrower.
4. Cut down all four corners of the carton and lay the panels flat.
5. Hold onto the lower handle and pull the snowthrower off the
carton.
IMPORTANT: DO NOT back over cables.
6. Remove the packing material from the handle assembly.
Snowthrower - Assembled Position
Figure 2
10
Auger Drive Lever
Auger
Drive Cable
Chute
Deflector
Crank
Assembly
Upper Handle
T-Knob
HANDLE ASSEMBLY
Install Upper Handle
1. Remove the T-knobs (
A
, Figure 3) and U-bolts from the lower
handle (
B
).
2. Put the upper handle (
C
) in the operating position.
3. Install the U-bolts and tighten the T-knobs.
NOTE: Make sure that the cable is not pinched between the
upper and lower handle. Make sure the cable is routed as shown
in Figure 3.
Handle Assembly
Figure 3
A
C
B
ASSEMBLY
Not
for
Reproduction
Summary of Contents for C950-52844-1
