Chute Clean-out Too
l
9. It is important that all cables be routed through the cable guide and
remain positioned on the left side of the hex rod. See Figure 10.
NOTE: An extension cord may be fastened with a cable tie to the
rear of the auger housing for shipping purposes. Cut the cable tie and
remove it before operating the snow thrower.
CAUTION: Prior to operating your snow thrower, refer to Auger
Control Test in the “Operating” section. Read and follow all
instructions carefully, and perform all adjustments to verify your
snow thrower is operating safely and properly.
Clean-Out Tool
The clean-out tool is mounted to the rear of the auger housing with a
mounting clip and a cable tie at the factory. Cut the cable tie before
operating the snow thrower. See Figure 11.
WARNING: Never use your hands to clean snow and
ice from the chute assembly or auger housing.
Shear Pin Storage (optional)
Replacement auger shear pins are included with this manual (or
stowed in the plastic handle panel).
Refer to Augers in the Maintain-
ance Section for more
information regarding shear pin replacement.
Figure 11
Figure 10
10
ASSEMBLY
Summary of Contents for C459-52925
Page 2: ...2 199260 07 21 05 BY Printed in U S A 02488 ...
Page 7: ...NOTES 7 ...
Page 46: ...NOTES 7 ...
