9
Screwdriver
9. Tighten blade nut firmly with a
wrench while holding screwdriver
in position.
10. Remove the screwdriver.
11. Turn blade by hand. If the blade
binds against the shield, or appears
to be uneven, the blade is not cen-
tered, and you must reinstall.
NOTE: To remove blade, insert screw-
driver into aligned holes. Unthread the
nut and remove parts. Be sure to store
parts and instructions for future use.
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Line Limiter
Blade
Primer Bulb
Handlebar
Starter Handle
Throttle Trigger
Choke
Lever
Shield
Trimmer Head
Shaft
Muffler
ON/OFF Switch
Coupler
Blade
ON/OFF SWITCH
The
ON/OFF
switch is located on the
trigger handle and is used to stop the
engine. Move the switch to the
OFF
position to stop the engine.
PRIMER BULB
The
PRIMER BULB
removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
CHOKE
The
CHOKE
helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the
FULL CHOKE
position. After the en-
gine attempts to start, move the choke
lever to the
HALF CHOKE
position. Once
engine has started, move the choke le-
ver to the
OFF CHOKE
position.
COUPLER
The
COUPLER
enables optional at-
tachments to be installed on the unit.
BEFORE STARTING ENGINE
WARNING:
Be sure to read
the fuel information in the safety rules
before you begin. If you do not under-
stand the safety rules, do not attempt
to fuel your unit. Contact your Sears
Service Centre.
FUELING ENGINE
WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled en-
gine oil. We recommend Craftsman
brand synthetic oil. Mix gasoline and oil
