11
SPARK PLUG
Replace spark plug at the beginning of
each mowing season or after every 100
hours of operation, which ever occurs
fi rst. Spark plug type and gap setting are
shown in the “PRODUCT SPECIFICA-
TIONS” section of this manual.
CLEANING
IMPORTANT:
For best performance, keep
mower housing free of built-up grass and
trash. Clean the un der side of your mower
after each use.
CAUTION:
Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
• Clean the underside of your lawn mower
by scraping to remove build-up of grass
and trash.
• Clean engine often to keep trash from
accumulating. A clogged engine runs
hotter and shortens engine life.
• Keep fi nished surfaces and wheels free
of all gasoline, oil, etc.
• We do not recommend using a garden
hose to clean lawn mower unless the
electrical system, muffl er, air fi lter and
carburetor are covered to keep water
out. Water in engine can result in short-
ened engine life.
LIFT
COVER
Air fi lter body
Air fi lter cover
Air fi lter
elements
excess oil. Do not satu rate.
7. Install fi lter element into fi lter body.
8. Install fi lter cover and press down to
snap into place.
MUFFLER
Inspect and replace corroded muffl er as it
could create a fi re hazard and/or dam age.
SERVICE AND ADJUSTMENTS
WARNING:
To avoid serious injury, before
per form ing any service or ad just ments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See “TO ADJUST CUTTING HEIGHT” in
the Operation sec tion of this manual.
REAR DEFLECTOR
The rear defl ector, attached between the rear
wheels of your mower, is provided to min i mize
the possibility that objects will be thrown out
of the rear of the mower into the operator's
mowing position. If the defl ector becomes
dam aged, it should be replaced.
DISCHARGE GUARD
The discharge guard, attached to the
dis charge opening of your lawn mower, is
pro vided to prevent the possibility of injury
re sult ing from objects being thrown out of
the dis charge opening into the operator
mowing position. If the dis charge guard
becomes dam aged, it should be replaced.
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and wire tie(s)
securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mount ing pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and po si tion holes
onto mount ing pins on handle bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
Lower handle
Handle
bracket
Hairpin cotter
SQUEEZE
TO ADJUST
Mounting pin