Read Operating Instructions
Study, understand and follow all instructions in this
manual before operating the jack. Failure to heed these
warnings may result in loss of load, damage to the jack
and/or jack failure resulting in personal injury or property
damage.
Position the Jack
Position the jack to only lift on the areas of the vehicle
specified by the vehicle manufacturer.
Use Support Stands
After lifting the vehicle always support the load with
appropriately rated vehicle supports stands before
working on the vehicle.
Do Not Overload Jack
Do not overload this jack beyond its rated capacity.
Overloading this jack beyond its rated capacity can
cause damage to or failure of the jack.
Use on Hard Level Surface
This jack is designed only for use on hard level surfaces
capable of sustaining the load. Use on other than hard
level surfaces can result in jack instability and possible
loss of load.
Center Load on Jack Saddle
Center load on jack saddle before lifting vehicle.
Off-center loads and loads lifted when the jack is not
level can cause loss of load or damage to the jack.
KEEP HANDS AND FEET CLEAR OF THE JACK
HINGE MECHANISM AND GROUND CONTACT AREA
WHEN LOWERING THE LOAD !
SAFETY INSTRUCTIONS
THIS JACK IS DESIGNED ONLY FOR LIFTING PART OF THE
TOTAL VEHICLE. DO NOT MOVE OR DOLLY THE VEHICLE
WHILE IT IS ON THE JACK.
THIS JACK IS A LIFTING DEVICE ONLY!
WARRANTY
CRAFTSMAN ONE YEAR FULL WARRANTY
If this Craftsman product fails due to a defect in material
or workmanship within one year from the date of
purchase, return it to any Sears store or other Craftsman
outlet in the United States for free replacement.
This warranty applies for only 90 days from the date of
purchase if this product is ever used for commercial or
rental purposes.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
1
Front Wheels
Lifting Arm
Saddle
Assembly
Handle Assembly
• Prior to assembly please remove the clip attached to
the handle socket (picture 1).
• Refer to picture 2 when performing this step. Take off
the screw located on handle piece 1. Attach handle
piece 1 and 2 making sure to align the holes on both
pieces. Reinsert the screw and tighten it.
• Fully unfasten the screw located in the Handle
Socket to insert the assembled handle (picture 3).
• Line up the square hole located at the bottom of the
handle over the square bolt inside the Handle Socket.
• Secure the handle in place by tightening the screw
in the Handle Socket.
ASSEMBLY
FRONT OF THE JACK
Rear Swivel Casters
Handle
Handle
Socket Screw
Plunger
BACK OF THE JACK
POWER UNIT
DESCRIPTION
Craftsman model 50167 features an 8,000 lbs.
maximum capacity. Lifting range for this jack is 4 inches
to 21 inches. Jack features an overload valve which
helps prevent equipment failure. Bypass system
provides safe operation.
Specifications
Compact design allows use in confined spaces
Maximum load capacity.......................4 tons (8000 lbs.)
Lift range..................................................4 to 21 inches
Size (LxWxH)..............................29.27” x 15.82” x 7.07”
Weight w/handle..............................................99.23 lbs.
U-Joint Release Valve
Oil Fill Plug
Grease Fitting
