19
FLUSH SANDING (See Fig. 10)
Flush sanding can be performed with the front edge of this sander. Upon completion
of sanding operation, turn sander off and wait until sanding disc comes to a complete
stop before removing from workpiece.
WARNING:
Empty dust bag before storage to help prevent possible fire
hazard, especially when resin coating or linseed oil finishes have been sanded.
!
NOTE: Empty dust bag frequently when sanding so dust collection system
works properly.
OPERATION cont.
Fig. 10
3
4
ORBITAL MOTION (see Fig. 9)
As shown in Figure 9, the orbit of the sander is 1/8-in. in diameter so the sandpaper
moves in tiny circles at very high speed, allowing the sander to move easily.
This orbital action duplicates a “hand sanding” motion for more aggressive sanding as you
push the sander forward. This powerful orbital action is ideal for heavy-duty sanding
applications, such as:
1. Removing old finishes
2. Smoothing rough wood
3. Sanding stock down
to required dimensions
4. Finishing surfaces
that are to be painted.
Fig. 9
1/8-in Orbital Diameter
18
SELECTING THE RIGHT SANDPAPER
1.
Aluminum oxide, silicon carbide and other synthetic abrasives are best for power sanding.
2.
Natural abrasives such as flint and garnet are too soft for economical use in power sanding.
3.
Coarse grit will remove the most material and finer grit will give you the best finish in all
sanding operations.
4.
The condition of the surface to be sanded will determine which grit will do the job.
5.
If the surface is rough:
• Sta
rt with a coarse grit and sand until the surface is uniform.
• Then use medium to rem
ove any scratches left by the coarse grit.
•
Then use a finer grit for finishing the surface.
Selecting the correct grit and type of sandpaper is an extremely important decision that
will allow you to achieve the best quality sanding finish.
WARNING:
DO NOT
wear loose clothing or jewelry when operating sander.
They could get caught in moving parts, causing serious injury. Keep head away from
sander and sanding area. Hair could be drawn into sander, causing serious injury.
!
NOTE: DO NOT
use the sander without sandpaper. This will damage the cushion.
NOTE: ALWAYS
continue sanding with each grit until the surface is uniform.
OPERATION cont.
OPERATION cont.
SANDING TIPS
1.
DO NOT force the sander.
The weight of the sander supplies adequate pressure on
the workpiece. Let the sander and the sandpaper’s grit do the work.
• Applying additional pressure will only slow down the motor, wear the sandpaper
out faster and reduce the sander’s orbital speed.
• Excessive pressure will overload the motor and cause possible damage to the
sander from the motor overheating.
• Excessive pressure will also result in a poor quality finish.
2. Any existing finish or resin on wood may soften from the heat of the friction and cause
the sandpaper to load-up faster.
3. Inspect sandpaper frequently and change paper when grit is worn and not able to
perform properly.
4.
DO NOT
sand in one spot for too long a time because the sander’s rapid action may
remove too much material and make the surface uneven.
CAUTION:
To ensure proper brake operation after extended use, periodically
check its operation by removing the sanding disc and running the sander without
load (off the workpiece). The backing pad should not take longer than 6 seconds
to stop. If it takes longer than 6 seconds to stop, then brake should be replaced.
!
NOTE: The brake is available and can be purchased at the nearest Sears Parts
and Repair Center.
USING YOUR SANDER cont.
