35
*3-Function Remotes (315 MHz)
If provided with your garage
door opener, the large button
is factory programmed to
operate it. Additional buttons
on any Security
✚
®
3-Function
remote or compact remote
can be programmed to
operate other Security
✚
®
garage door openers.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or
keyless entry you wish to use.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON
USING THE DOOR CONTROL
1. Press and release the “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
*
that
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
✚
®
315 MHz remote controls.
1. Press and hold the button on the
hand-held remote
*
that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the door
control.
3. Continue holding both buttons while
you press the push bar on the door
control (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
LOCK
LIGHT
LOCK
LIGHT
LOCK
LIGHT
LOCK
LIGHT
NOTICE:
If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
