|
-21-
information
When moving the engine throttle to the minimum
(rightmost), the output power of engine is low. Please
don’t operate the machine, if not, the machine will be
flameout stop due to low engine output power.
Working techniques
This section describes basic working technique with
safety rules for using a high pressure washer to perform
your cleaning work. This information is no substitute for
professional skills and experience. If you get into a
situation where you feel unsafe, stop and seek expert
advice. Do not attempt any task that you feel unsure of!
WARNING
Engine exhaust is hot, and it can cause serious burns.
Engine exhaust contains Carbon Monoxide (CO), a
poison gas. Breathing CO can cause unconsciousness,
serious injury, or death. Always position your machine
so that exhaust is directed away from your face and
body.
information
Observe all country-specific or municipal rules and
regulations for trimming hedges.
Do not use your machine during other people's normal
rest periods.
Distance from cleaning surfaces
The distance between the spray nozzle and the
cleaning surface is one of the important factors that
affects the impact force of the water. The impact force
of the water increases as the spray nozzle is moved
closer to the surface.
You can vary the impact force by controlling:
-
The nozzle’s spray pattern.
-
The nozzle’s angle to the cleaning surface.
-
The nozzle’s distance from the cleaning surface.
Never use a narrow high impact stream on a surface
that is susceptible to damage. Avoid spraying windows
with a narrow high impact stream or turbo nozzle. Doing
so may break the glass.
1. Before triggering the spray gun, select a spray
nozzle with a wide spray pattern.
2. Place the nozzle approximately 6~8inch (16-20cm)
away from the cleaning surface.
3. Hold the nozzle at a 45 degree angle (A) to the
cleaning surface with a distance (D)
6~8inch(15~20cm), then trigger the spray gun.
4. Vary the pattern spray angle and the distance to the
cleaning surface until optimum cleaning efficiency
is achieved without damaging the surface.
Spray nozzles selection
The spray pattern can be adjusted by installing an
appropriate spray pattern nozzle. The pressure washer
comes with five (5) types of high-pressure nozzles that
can be connected to the end of spray wand, 0°, 15°, 25°,
40° and a detergent nozzle. The spray tips vary the
spray pattern as shown below.
0
o
RED
40
o
WHITE
soaper
BLACK
15
o
YELLOW
25
o
GREEN
-
0° (red) - Thin and powerful stream of water for
difficult stains and debris removal.
-
15° (yellow) - Thin angled spray for focused
cleaning.
-
25° (green) - Medium angled spray for focused
cleaning.
-
40° (white) - Large fan pattern for wider cleaning
applications.
-
Detergent (black) - This nozzle must be used in
conjunction with a cleaning detergent at low
pressure. Only use this nozzle when using a
detergent or cleaning solution.
WARNING
Before removing, installing or adjusting any spray
nozzle or accessory, make sure to shut off the pressure
washer, relieve system pressure, and engage the spray
trigger locking latch, otherwise severe injury may result.
