|
-10-
•
Only use cold water.
•
Always disconnect spark plug wire and place wire
where it can not contact spark plug to prevent
accidental starting when setting up, transporting,
adjusting or making repairs except carburetor
adjustments.
•
Always hold the spray attachment firmly with two
hands when performing your cleaning work. The
spray jet causes reactive forces on the spray
attachment in a direction opposite to the direction of
the spray (recoil or kickback). Hold the spray
attachment firmly with both hands in order to control
the reactive forces, including any additional torque
produced when using angled spray attachments or an
angled spray wand.
•
Do not operate a high pressure washer with one hand.
Serious injury to the operator, helpers, bystanders or
any combination of these persons may result from
one-handed operation.
The high pressure washer
MUST be used with two hands!
•
Always engage the trigger safety latch in the safe
position when spraying is stopped even if only for a
few moments.
•
Never put hand or fingers over the spray tip while
operating the machine.
•
Operate the high pressure washer only in a
well-ventilated outdoor area.
Never start or run the
engine inside a closed room or building. Exhaust
fumes contain dangerous carbon monoxide.
•
Never operate the machine at night, at times of heavy
fog, or at any other times when your field of vision
might be limited and it would be difficult to maintain a
clear view of the working area.
•
During rain, storms at times of strong or gale-force
winds, or at any other times when weather conditions
might make it unsafe to use this machine.
•
Do not allow any material to block the cooling slots.
•
Carefully plan your cleaning operation in advance.
Never start cleaning until you have a clear work area.
•
Maintain footing and balance at all times. Do not
stand on slippery, uneven or unstable surfaces. Do
not operate the high pressure washer in odd position
or on a ladder or ladders.
•
Keep exhaust area clear of flammable debris. Avoid
contact hot surfaces during and immediately after
operation.
•
Do not use a pressure washer to clean pressure
washer. The solid jet of high pressure water may
damage parts of the machine.
Maintain in good work order
CAUTION
All high pressure washer service, other than the items
listed in the maintenance section of this manual, should
be performed by authorized service dealer or
competent high pressure washer service personnel.
WARNING
Only use high-quality replacement parts in order to
avoid the risk of accidents and damage to the power
tool. If you have any questions in this respect, consult
an authorized dealer or service center. CRAFTOP
recommends the use of genuine spare parts. They are
specifically designed to match your model and meet
your performance requirements.
•
To reduce the risk of injury, always shut off the engine
before carrying out any maintenance or repairs or
cleaning the machine, only excepts carburetor and
idle speed adjustments.
•
Check the machine for loose/missing nuts, bolts, and
screws. Tighten and/or replace as needed.
•
Do not turn the engine over on the starter with the
spark plug boot or spark plug removed since there is
otherwise a risk of fire from uncontained sparking.
•
Check fuel system for leaks due to fuel tank damage,
especially if the machine is dropped accidently. If
damages or leaks are found, do not use the machine
any more, otherwise serious personal injury or
property damage may occur. Have your machine
repaired by an authorized dealer or service center
before using.
•
Check the fuel filler cap for leaks at regular intervals.
•
Check the engine oil level is located at the proper
position.
•
To reduce the risk of fire, do not service or store your
machine near open flames.
•
Use only a spark plug type which is approved by
CRAFTOP and make sure it is in good condition.
•
Inspect the ignition lead (insulation in good condition,
secure connection).
•
Check the condition of the muffler. To reduce the risk
of fire and damage to hearing, do not operate your
machine if the muffler is damaged or missing.
•
Do not touch a the muffler, spark plug, or other
metallic parts of the engine while the engine is
running or immediately shutting down, otherwise burn
injury will result.
Transporting your high pressure washer
Avoid accidental starting. Transport or move the
machine only with empty fuel tank. Be sure the engine
switch is off before transporting the machine.
