4. Hanging Bracket Installation.
page 3
3. Installation Preparation.
This fan can be mounted as a
flushmount
on a regular ceiling
only
.
Downrod
installations
are
not
available for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
downrod
installation
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400
square feet (37.2 square meters).
12f
t.
- 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
7 feet
(2.13m)
(76cm)
30
inches
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to
the OFF position.
WARNING:
Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be sure the
outlet box is securely attached to the building structure
and can support the full weight of the fan. Ensure outlet
box is clearly marked "Suitable for Fan Support." If not, it
must be replaced with an approved outlet box. Failure to
do so can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and
that a ground wire (
GREEN
or bare) is present.
Remove 4 motor mounting screws and lock washers
from hanging bracket--
save for later use.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided with
new or original outlet box.* Pull electrical wiring from
outlet box through center hole in the hanging bracket.
*
Note
: It is very important that you use the proper
hardware when installing the hanging bracket as this will
support the fan.
ON
OFF
ON
OFF
hanging bracket
outlet box
spring washers
outlet box screws
flat washers
lock
washers
motor
mounting
screws
hanging bracket
