page 9
dimmer
switch
wall control
wire
wire
wire
12V battery
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do
not
wish
to use the handheld remote control, please
proceed to Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [
Refer to
diagram 1
.
]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall
control. [
Refer to
diagram 2
.
]
Since this fan is coming with an LED light kit,
the dimmer switch (labeled
ON
and
D
) has
been pre-set to the "ON" position. If you do not
wish to have dimming capability, please move
the switch to the "
OFF
“ (
D
) position.
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
IMPORTANT
: Store the handheld remote
control away from excess heat or humidity. To
prevent damage to handheld remote control,
remove the battery if remote control will not be
used for long periods.
(top)
(bottom)
remote
control
cover
diagram 1
diagram 2
I
II
IV
VI
III
V
wall
control
remote control
cover,
BOTTOM
post
hole
diagram 3
post
hole
remote control
cover,
TOP
I
II
IV
VI
III
V
