page 7
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then tighten
both screws securely.
8. Blade Assembly.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Time Saver
: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat procedure for the remaining
blades.
Remove blade arm screws/lock washers from
underside of motor.
Align blade arm holes with
motor screw holes and attach blade arm with
blade arm screws/lock washers. Before securing
screws/lock washers permanently, repeat this
procedure with remaining blade arms. Secure
all screws/lock washers.
Note:
Tighten blade arm screws/lock washers
twice a year.
9. Light Kit Assembly (Optional).
Remove 3 screws from motor plate on
underside of motor housing. Align small
holes in center of fitter plate with holes in
motor plate, allowing molex connections
from motor housing to come through hole
in middle of fitter plate. Re-insert screws
that were just removed and securely
tighten all 3 screws with a Phillips
screwdriver.
["Light Kit Assembly" continued on next
page.]
canopy
blade arm
screws/
lock washers
blade
blade arm
blade attachment
screws and washers
motor housing
motor plate
fitter plate
screw
molex connections
hanging
bracket
screw
screw
motor housing
