13
Step 13
Wiring Instructions
NOTE: Use instructions packed with celing fan to wire ceiling fan.
WARNING: To avoid overheating and possible damage to his device and
other equipment, do not install to control a receptacle, fluorescent lighting,
transformer, or motor-operated appliance other than the fans for which
this control is intended. Use this device only with copper or copper clad
wire. With aluminum wire use only devices marked CO/ALR.
1. Remove insulation to expose 3/4" bare copper wire at end of circuit
conductors. Keep wire ends straight.
2. Connect wires per wiring diagram as follows: black leads (one each)
to black (hot) line, green ground wire to copper outlet wire. Hold
bare ends together. Push wires firmly into wire connector. Screw
connector on clockwise until no bare copper shows. Secure connector
with electrical tape.
CAUTION: Never attach white neutral wire to TCS+ Control
3. Make sure battery is properly installed in switch. The switch should
already have this preinstalled, but double check before installing the
mounting plate (see diagram). Note: The battery replacement code is
23A 12Volt.
4. Mount device with long mounting screws (provided). Install wallplate
and tighten cover screws.
5. Restore power at circuit breaker or fuse. Installation is complete.
Neutral
(White Wire)
Hot Line
(Black Wire)
SINGLE POLE
Neutral
(White Wire)
Load
(Black Wire)
23A 12Volt
Battery
HI
MED
LOW
OFF
L-1
L-2
REV
OFF
ON
12V. BATT.
SUPER
23A 12V
1 2 3 4
ON
Ground Wire
(Copper Wire)
Ground Wire
(Green Wire)
11
Step 11
Attach canopy (#3) to the
mounting bracket by placing
screws (S2) into slot in canopy.
Twist clockwise to lock
into place. Tighten screws firmly.
Bottom of Canopy
Screws (S2)
Canopy (3)
Ceiling
12
Step 12
Install halogen light bulb into fan. Seat bulb firmly into socket as shown.
Then install glass by raising glass to fan and turning glass clockwise
until firmly seated.
Halogen Bulb
