page 9
10. Light Kit Assembly, 4-light Options.
Remove 3 screws from top of light kit fitter.
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic
that holds these 2 wires together.
Next, locate WHITE and BLACK wires in light
kit fitter labeled FOR LIGHT.
Connect WHITE wire from light kit fitter to
WHITE wire from switch housing. Connect
BLACK wire from light kit fitter to BLUE (or
BLACK) wire from switch housing. Be sure
molex connections snap together securely.
Align holes in light kit fitter with holes in
switch housing. [NOTE: The gap on the top
edge of the light kit fitter must align with
reverse switch on the switch housing for the
proper fit.] Attach light kit fitter with 3 screws
that were previously removed. Secure all
3 screws with a Phillips screwdriver.
Loosen thumbscrews in light kit fitter.
Attach shades using thumbscrews. Do NOT
overtighten thumbscrews as shades may crack
or break.
Install bulbs included with light kit.
IMPORTANT: When replacing bulbs, please
allow bulbs and shades to cool down before
touching them.
Please proceed to Section 11 on the
following page to complete installation.
motor
housing
switch
housing
molex
connections
shade
light kit fitter
pull chain
extension
thumb-
screws
pull chain
extension
thumbscrew
switch
housing
reverse
switch
bulb
light kit fitter
*For Models P104 and P114, follow instructions on this page.
molex
connections
