page 8
8. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and partially loosen both screws. Lift
canopy to hanging bracket. Place rounded part
of slotted holes in canopy over loosened screws
in hanging bracket and push up. Twist canopy to
lock and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
9. Final Installation.
Locate 3 screws (with lock washers) in
hardware pack. Align holes in fitter plate
with holes on underside of motor, allowing
plug from motor housing to come through
hole in middle of fitter plate. Insert
screws/lock washers and use a Phillips
screwdriver to secure all screws.
[
Refer to
diagram 1
.
]
Locate nodules inside metal cover and
align with grooves on the underside of the
motor. Gently push up on metal cover and
turn to the
RIGHT (clockwise)
until it no
longer turns.
[
Refer to
diagram 2
.
]
hanging bracket
screw
antenna
canopy cover
canopy
screw
grooves
nodules
metal cover
diagram 1
diagram 2
screws/lock
washers
fitter plate
