page 10
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the wall
control but do
not
wish to use the handheld remote control,
please proceed to Section 11.
Gently pull on remote control cover to separate top and
bottom parts. [
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote control,
cut each wire on wall control (that was not previously
used)--use wire cutters to cut off each wire as close to the
wall control as possible. [
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall control. [
Refer
to
diagram 2
.
]
The dimmer switch (labeled
DIM
and
ON/OFF
) has been
pre-set to the "OFF" position (
ON
). If you wish to have
dimming capability, please move the switch to the "ON"
position (
DIM
). [
Refer to
diagram 2
.
]
Attach
black faceplate
to front of wall control; press
down firmly. [
Refer to
diagram 3
.
]
Align holes in wall control with posts located on
inside
of
TOP part of remote control cover and press together
firmly. Place wall control into BOTTOM part of remote
control cover, aligning posts in top of remote control
cover with post holes in the bottom. [
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and bottom of
remote control cover together until you hear a click at
each end, indicating that the remote control cover has
closed completely.
IMPORTANT
: Store the remote control away from excess
heat or humidity. To prevent damage to remote control,
remove the battery if remote control will not be used for
long periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When disposing of
household alkaline batteries, it is best to check with your
local and state recycling or household hazardous waste
coordinators concerning the specifics of the program in
your area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or www.earth911.org
for more information.
WARNING
:
Choking Hazard
- Small parts. Keep battery
away from children.
WARNING
: Non-rechargeable batteries are not to be
recharged; Do not mix different types of batteries such as
alkaline, carbon-zinc, or rechargeable batteries; Do not
mix old and new batteries; Batteries are to be inserted
with the correct polarity; Exhausted batteries are to be
removed from the product.
(top)
(bottom)
remote
control
cover
diagram 1
diagram 2
diagram 3
dimmer
switch
wall control
wire
wire
wire
12V battery
DIM ON
DIM ON
wall
control
face-
plate
remote control
cover,
BOTTOM
post
hole
post
hole
remote control
cover,
TOP
