page 5
7. Fan Assembly.
8. Motor Housing Assembly.
Remove motor assembly from temporary
hanging slot in hanging bracket. Carefully push
wiring and wire connectors into outlet box.
Slide one end of bar on motor assembly
through one of the openings in the hanging
bracket. Lift the other end of the and slide it
through opposite opening on hanging bracket.
Align holes in top of motor assembly with holes
in hanging bracket. Secure motor assembly to
hanging bracket with lock washers and motor
mounting screws that were previously removed
(Section 5, page 4).
Temporarily hold motor housing up to hanging
bracket to determine which 2 screws align with
slotted holes on top rim of motor housing. Put
motor housing down and
partially loosen
the 2
screws in the hanging bracket that correspond
to
slotted
holes in motor housing.
Remove
the
other
2 screws from the hanging bracket.
Raise motor housing to hanging bracket again,
allowing slotted holes in motor housing to
align with loosened screws in hanging bracket.
Twist motor housing to lock. Re-install the 2
screws that were previously removed and then
tighten all screws to secure motor housing.
motor
mounting
screws and
lock washers
motor
mounting
screws and
lock washers
hanging
bracket
opening
hanging
bracket
opening
slot
motor assembly
motor
housing
screws
motor
housing
screws
motor
housing
hanging
bracket
