page 7
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
hanging
bracket
canopy
screw
6. Wiring. (cont.)
(wiring for wall control)
[
PLEASE NOTE
: Wall and/or handheld remote
control must be used for fan to operate.
If you
do
not
wish to use the wall control, please proceed
to Section 7 below to continue with fan
installation.
]
To install wall control
, remove existing wall
switch. Wire one of the
wall controls with wire
connectors provided
as shown in diagram at
right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire connectors
into outlet box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT
: Wall control will not function
unless battery is installed.
Since this fan comes with an LED light kit, the
dimmer switch (labeled
ON
and
D
) has been
pre-set to the "ON" position (
ON
). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (
D
).
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
plate (included) to wall control using 2 screws
provided with the wall control.
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
12V battery
dimmer
switch
plate
I
I I
IV
VI
VI
I
I
I
I
I
I
V
screw
canopy cover
