Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through
holes in midde of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate and
partially loosen the other 2 screws.
Connect
WHITE
wire from LED light kit to
WHITE
wire from motor housing. Connect
BLACK
wire
from LED light kit to
BLACK
(or
BLUE
) wire from
motor housing. Be sure that molex connections
snap together completely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws
in light kit fitter. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws securely.
["Light Kit Assembly" continued on next page.]
page 8
8. Blade Assembly.
9. Light Kit Assembly.
motor
housing
blade
blade arm
blade attachment
screws/washers
blade arm screws
and lock washers
motor housing
motor plate
fitter plate
LED light kit
molex
connections
motor housing
fitter plate
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Locate 12 blade attachment screws/washers in one
of the hardware packs. Place blade arm on
UNDERSIDE
of blade, aligning holes in blade arm
with holes in blade as shown. Insert 3 blade
attachment screws/washers from
TOPSIDE
of blade
with fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
). Align blade arm
holes with motor screw holes and attach blade
arm with blade arm screws (along with lock
washers). Before securing screws permanently,
repeat with remaining blade arms. Securely
tighten all screws.
NOTE
: Tighten blade arm screws twice a year.
