Craftex CX904, Manual

Page: 12 / 28

12
screws. See figure 5. (Hardware not
supplied)
Figure 5 Direct Mount
Assembly
With the hardware listed in the inventory
section,
completely assemble the
CX904 by attaching the tool rest and
safety shield.
1. Connect safety shield to spark
deflector using (1) M4-.7 x 40 Phillips head
screws and (1) 4mm flat washer, securing it
in place with (1) flange nut as shown in
figure 6 below.
2. Connect the safety shield assembly
to right side of grinder using (2) M4-.7 x 8
Phillips head screws with captive flat lock
washers as seen in figure 6 below.
Figure 6
3. Connect each tool rest to the grinder
using (2) 4mm flat washers and (2) M4-.7 x
10 wing bolts as seen in figure 7 below.
Figure 7
Adjusting Tool Rests
The tool rest supports the workpiece
when grinding hence it is important to
adjust the tool rest correctly.
The tool rest should be positioned at
1/16" - 1/8" from the grinding wheel. As
the grinding wheel wears, and the gap
between the grinding wheel and tool rest
increases, adjust the tool rest closer to
the grinding wheel.
Figure 8
WARNING!
Do not grind without the tool rest in place.
The grinding wheel must be positioned in
place
before operation. Free hand
grinding or a large gap between tool rest
and grinding wheel will increase the
possibility of kickback.