Craftex CX904, Manual

Page: 7 / 28

7
PLUG AND GROUNDING
REQUIREMENTS
This machine must be grounded so that
in the event of certain malfunctions it will
reduce the chances of electrical shock
by providing a path of least resistance
for the electric current to travel through.
For this reason the CX904 comes with a
cord equipped with an equipment
grounding wire that leads in to the
grounding prong on the plug.
NOTE
The three-prong plug is only to be
plugged in to matching receptacle that
is properly installed according to the
local electrical codes and standards.
Under no circumstances should you
modify the plug to make it fit in a
receptacle that it is not meant for this
configuration. (see figure A)
Figure A
If there is an improper connection of a
machine grounding wire it may result in
a heightened risk of electric shock. If
repair or replacement of the power cord
is necessary in the future please consult
a licensed electrician.
NOTE
If ever you notice damage or ware to
either the cord or plug disconnect it
immediately from the power supply and
have it replaced by a licensed electrician
or service tech before any further use of
the machine.
USE WITH EXTENSION CORDS
If you absolutely must require the use of
an extension cord with your machine do
so, on a temporary short-term basis
only.
NOTE
We recommend that you do not use an
extension cord with this machine. Also the
longer the extension cord the greater the
possibility of voltage drop that can cause
the motor to work harder as it will be
under powered which in turn will cause it
to draw more amps. This may cause the
thermal overload to trip or even the
breaker in your electrical panel. It may
also cause the extension cord to heat up
which can be a potential fire hazard.
If an extension cord is used with this
machine it must have a ground wire with a
plug that attaches to the one currently
installed on your machine. The extension
cord must also meet the following
specifications below:
Minimum Wire Gauge: 16 AWG
Maximum Cord Length: 50 ft.