11
AUTO SHUT-OFF
BRACKET
The auto shut-off bracket should be
adjusted properly, so that the band saw
shuts OFF automatically when a cut is
complete.
To adjust the auto shut-off bracket:
With the headstock in complete down
position, loosen the screw securing the auto
shut-off bracket.
Push down on the auto shut-off bracket, so
that the off switch is completely depressed.
While keeping the auto shut-off bracket
depressed tighten the screw securing the
stop bracket.
Figure-8 Adjusting the stop bracket
TEST RUN
Once you have assembled your band saw
completely, it is then time for a test run to
make sure that it works properly and is
ready for operation.
Read and understand the instructions given
in this manual before turning the machine
on.
Remove all the tools and foreign objects
from the machine.
Wear safety glasses and secure loose
clothing and long hair.
Connect the cord to the power outlet.
Raise the band saw with hand and turn on
the saw.
The band saw should run smoothly with
little or no vibration.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and investigate to find out
the problem with your machine.
WARNING!
For the protection of your eyes, make
sure you are wearing safety glasses or
safety goggles while doing the test run.
