12
TEST RUN
Now that you have assembled your
machine completely, it is time for a test run
to make sure that the machine works
properly and is ready for operation.
All the tools and objects used for
assembling the machine should be
removed and cleared away during the test
run.
Plug the cord to the power outlet and turn
the dust collector ON. See if the dust
collector operates correctly.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, shut off the
machine immediately and disconnect the
cord from the power source. Check all the
parts you have assembled once again and
investigate to find out the problem.
SPEED CHANGES
The CX109 features 3 speeds and the
speeds changes can be performed by
positioning the belt on different grooves on
the motor pulley and saw pulley.
To change the speed:
Make sure the switch is in the OFF position
the cord is disconnected from the power
source.
Open the pulley cover to access the
pulleys. Loosen the screw on the motor
bracket shown in figure-14. This will loosen
the tension on the belt.
Figure-14 Loosening the tension on the belt
Once the belt tension is released, position
the belt on to the pulleys grooves to obtain
the desired speed. See figure-15.
Figure-15 Belt position on the pulleys for
speed changes
WARNING!
Before starting the dust collector, make
sure that you have read and understood
the manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
