10
Align the holes on the band saw base with
the holes on the stand. Secure the band
saw onto the stand from under the base
using two long bolts, washers and nuts
(provided) as shown in figure-7.
Figure-7 Securing the band saw onto the
stand
Insert the work stop rod through the hole in
the bed of the saw and lock it in position by
tightening the set screw shown in figure-8.
Now, take the work stop and slide it over
the rod and secure it by tightening the
thumb screw shown in figure-8.
Figure-8 Installing the work stop
Take the belt cover and slide in over the
pulleys as shown in figure-9 and secure it
by tightening two screws.
Figure-9 Installing the motor cover
VERTICAL CUTTING
WORK TABLE
CX109 can easily be set up for vertical use.
Notching, Slitting and contour work maybe
be done with CX109 in the vertical position.
Vertical cutting work table is used on the
band saw only in vertical cutting mode.
When using the saw in horizontal position,
make sure the cutting table is removed.
To install the vertical cutting table:
1.
Make sure the power cord is
disconnected from power source.
2.
Remove the bolt shown in figure-10 so
that the band saw can be positioned at
90°.
