9
ASSEMBLY
To assemble the CX104 band saw, follow
the instructions given below.
Attach the two panels to one of the legs as
shown in figure-4 using screws, washers
and nuts provided. Do not tighten at this
time.
Figure-4 Attaching the panels to the leg
Attach the second leg to the panels as
shown in figure-5 using screws, washers
and nuts provided. Make sure the panels
and the legs are attached properly and
tighten all the screws and nuts.
Figure-5 Installing the second leg
Now, place the stand upside down and
install the rubber feet to the stand as shown
in figure-6 using screws provided.
Figure-6 Installing the rubber feet
Remove the protective plastic on the motor
shaft. Position the pulley on the shaft, until
it is flush with the end of the shaft and
tighten the set screw. See Figure 7.
Figure-7 Installing the motor pulley
IMPORTANT
You have to mount the motor to the band
saw base before installing the band saw
on the stand.
