ASSEMBLY
Installing the Dust Hood
x bolts,
at washers and hex nuts provided. (See
stalling the Pedestal Switch
Attach the dust hood to the side on the
stand assembly by using the he
fl
Figure 9)
Figure 9: Installing dust hood
In
T
s
s
cap screws. There is a wire that comes
from the motor to the switch. You can
ass the excess motor wire to the stand
rough the hole located in the stand.
ee figure 10)
o install the pedestal switch, take the
witch and attach it to the stand using the
crew lock washers, flat washers and
p
th
(S
Figure 10: Installing pedestal switch
Installing the V-Belt
Your machine is provided with a V-belt
that goes around the motor pulley and
the cutterhead pulley.
o install the V-belt loosen the motor
r
a
t
d
e motor pulley taking it around the
Figure 11: Installing V-belt
Make sure that both the pulleys are
aligned and the V-belt goes straight up
and down.
T
b acket fasteners and slide the motor
tle upward. Now, put the V-belt aroun
li
th
cutterhead pulley. Then slide back the
motor downward and tighten the motor
bracket fasteners. (See Figure 11)
This machine produces large amount
of dust. To avoid respiratory illness do
not run it without the dust collection
system
13
