IDEX USER MANUAL
8
3.3. Assembling the Craftbot Printer
•
Remove the X-rail clamps
-
To ensure your product was delivered safely, there are two clamps on the
end of the X-rail. Safely remove these by using the hex key provided by
unscrewing the 2 screws on each clamp.
-
Slide the clamps out by wiggling them from side to side.
•
Install the filament guide tube holders
-
Select the desired position for the filament guide holders. Choose their
position so that the filament spool holders fit beside them.
•
Install the filament guide tubes
-
Locate the filament guide tubes.
-
Insert one end of the filament guide tubes into the filament guide tube
holder on top of the Craftbot appliance.
-
Push the other end into the hole on the top of the extruder.
•
Install the filament spool holders
-
Locate the filament spool holders.
-
Using a hex wrench, install the filament spool holder next to the filament
guide tube holders.
•
Mount the filament spools
-
Fit the filament spools onto the filament spool holders so that the lead
end keeps its course when the filament is fed into the filament guide tube
holder.
•
Attach the power cord
-
Ensure that the power switch on the Craftbot is set to the OFF position.
-
Plug the AC power cord into the power input an the back
of the unit.
-
Plug the power cord into a wall socket.
Summary of Contents for FLOW GENERATION IDEX
Page 1: ...IDEX USER MANUAL...
