IDEX USER MANUAL
27
5.
Go to SETTINGS
and then UPDATE
menu
6.
Press the RESCAN button until UPDATE FROM
PENDRIVE appears
7.
Tap the UPDATE FROM PENDRIVE to start the
update process
8.
Update is automatic, when it is ready, click on the
UPDATE FINISHED OK button.
9.
Do again the calibrations!!!
Troubleshooting:
If the FW update run into error, please do the following:
1.
Turn off the printer
2.
If a usb cable is connected to the printer’s side,
disconnect it
3.
With a piece of fifilament push and hold the reset
butttton (a littttle hole under the ethernet port)
4.
Turn on the printer and wait at least 5 seconds
5.
Release the butttton
6.
Turn offff then on the printer again
7.
Install the FW as above
Please do not interrupt the process or unplug the printer
during the firmware update.
Language
•
Select your language from the list
(EN, DE, HU, NL, FR, ES, IT)
Personalise
You can personalise your printer. There are several
options:
•
Which side would you like the head position to be at
pause?
•
Would you like the machine to go to XY reference at
the print finished?
•
Would you like the machine to go to XY reference at
the print terminated?
•
Would you like the bed to move down when the print
finished?
•
Would you like to extrude when the hotend is cold?
•
Warning before homing or jogging to check the build
plate for any objects.
•
Would you like the machine to check the buildplate
is present?
•
Would you like the machine go to the pause position\
nif you open the door while printing?
•
Would you like the machine measure print bed level\
nbefore you starting print?
•
Would you like to switch to expert calibration mode?
Summary of Contents for FLOW GENERATION IDEX
Page 1: ...IDEX USER MANUAL...
