IDEX USER MANUAL
43
Nozzle hand drill bits
To help drill the clogged nozzle during the cleaning
process.
There are 3 sizes:
•
Ø 0,6 mm
•
Ø 0,8 mm
•
Ø 1 mm
Caution! Don’t use the drill to clean until the extruder is
heated to above 200 degrees.
Alcohol prep pads
Keep the Kapton foil cleaned whith alcohol prep pads.
Caution! Avoid contact with the eyes and please keep
out of reach of children.
After using this product for wiping, it will be completely
evaporated leaving and no residue after about 30
seconds.
Wire brush
Use the wire brush to clean the nozzle and the feed
gears.
Don’t forget to heat up the nozzle before cleaning.
Caution! The brush head is made from copper wire, and
it is relatively soft. Therefore, the brush head may be
deformed or warped in transportation.
Wire cut
For trimming the model or cutting off the various 3D
printer filaments. Always cut a clean end before placing
the filament into the extruder gear.
Nozzle needles
To help remove any excess plastic when clearing jams
from the nozzle and any other hard to reach places like
the feed gears.
There are 4 sizes:
•
0,25 mm
•
0,4 mm
•
0,6 mm
•
0,8 mm
Caution! The nozzle cleaning needles are sharp; please
keep them safe and out of the reach of children.
Summary of Contents for FLOW GENERATION IDEX
Page 1: ...IDEX USER MANUAL...
