Crafco SUPER SHOT 60, Parts Manual

Page: 76 / 140

Super Shot 60 Propane Melter Part Manual
Chapter 8 Troubleshooting
©2018 by Crafco, Inc. All Rights Reserved
………………...…………………………..……………...Illustrated Parts List 8-10
8.1 Sealant is Heating Slowly
Table 8-10 Burner Flame Adjustment (continue)
Step Burner Flame Adjustment
6 Lower the burner and slide the burner out of the hole in the deck.
7
Inspect the burner ring along with the twelve small diameter holes in the center section of the
burner. You may need to use a small metal pick to unplug these holes.
8
Turn the burner over to dump out any small pieces of debris, after that turn the burn back
over. Shop air can be used to blow out any debris inside the burner. If needed you can
remove the center section to allow access.
9 Check the air inlet for the proper air setting. Locate the conduit locknut near the area that the
propane hoses attaches to the burner, loosen this nut and turn the air spacer clockwise until it
stops against the burner body. Use a marker to mark a line across the air spacer and burner
body. Turn the air spacer four complete turn counter clockwise and secure it in place with the
conduit lock nut.
Table 8-11 Sealant is Heating Slowly
Step Sealant is Heating Slowly
1 With the material level half or less, open the loading lid and inspect the inside edge of the
material tank. Check if there is a buildup of old, dried out and hardened material along the top
half of the material tank.
2 If this is the case you will need to drain out (use up) the rest of the material inside the tank.
When the tank is empty, use an air chisel to remove this built up material. Remove as much
as possible all around the tank including the roof of the material tank. Remove all the old
sealant chunks from the bottom of the material tank. This should be done every year or as
conditions require.
3 Check your level of the heat transfer oil, the mark on the dipstick is for 70°F.
4 Check your records of the last service replacement of the heat transfer oil. If it has been
longer than 500 hours, or one year, you need to change your oil.
5 Many of Crafco, Inc. service centers can perform these service steps for you if you cannot.
Call your local service center to find out if they can.