Crafco SUPER SHOT 125, Parts Manual

Page: 50 / 230

Super Shot 125 Diesel Melter Part Manual
Chapter 6 Maintenance Instructions
©2017 by Crafco, Inc. All Rights Reserved………………..………………………………..….…Maintenance Instructions 6-2
6.7 Lug Nuts
Torque all nuts/bolts before first road use and after each wheel removal. Check and torque after
the first 10 miles (16 km), 25 miles (40 km), and again at 50 miles (80 km). Check periodically
thereafter.
Torque in stages as follows:
First stage 20-25 foot-pound (ft-lb) (89-111 N)
Second stage 50-60 foot pound (ft-lb) (222-266 N)
Third stage 90-120 foot pound (ft-lb) (400-534 N)
Tighten bolts and nuts in the sequence shown in Fig. 6-1 Lug bolt Tightening Sequence.
6.8 Brakes
Check the brakes daily.
6.9 Tongue Jack
Lubricate the tongue jack, using a good grade of bearing grease.
Fig. 6-1 Lug bolt Tightening Sequence
4-BOLT 5-BOLT 6-BOLT
1
2
3 4
1
2
3 4
5
1
2
3
4 5
6