Model 30 Pavement Router Manual
Illustrated parts Lists
Chapter 9
©2018 by Crafco, Inc. All Rights Reserved…………………………...………………………………..……………...Troubleshooting 9-29
9.11 Cutter Positioning
The following sections illustrate the spacing options for the different types of cutter heads available.
Cutter Positioning for Cutter Part Numbers 31134, 31136, 31137, 31149
9.11.1
Cutters can be aligned or staggered to configure the desired cut width. For wider cutting additional cutter
can be added to a single pin to achieve a smoother finished cut. Always use enough Hardened Spacers to
keep cutters appropriately positioned on the pin while still allowing the cutter to turn completely free.
Cutter Position for Cutter Part Number 31135 Shaved Cutter
9.11.2
Cutters can be aligned to configure the desired cut width. For wider cutting additional cutters can be added
to a single pin to achieve a smoother finished cut. Always use enough Hardened Spacers to keep cutters
appropriately positioned on the pin while still allowing the cutter to turn completely free. The main
consideration is placing equal number of cutters and spacers on opposite pins to maintain balance. Failure
to do so could result in permanent damage to the machine and possibly injury to the operator.
Figure 9.17 Cutter Positioning for 31134, 31136, 31137, 31149
Figure 9.18 Cutter Positioning for 31135
1/2” Cut
Staggered for wide cut
Add center cutter for wide cut
1/2” Cut
3/4” Cut
