Model 30 Pavement Router Manual
Maintenance Instructions
Chapter 6
©2018 by Crafco, Inc. All Rights Reserved………………..………………………………..….…How to Use a Multimeter 6-4
6.5 Maintenance Schedule
These required maintenance procedures should be performed at the recommended intervals. They
should also be included as part of any seasonal tune-up. Refer to Table 6-1 for regularly scheduled
maintenance. The following guidelines should also be followed:
•
Check fluid level in battery regularly.
•
Tighten all bolts on machine frequently.
•
Clean machine each day using compressed air or by wiping with rags, especially in area of
engine cooling fins.
* Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
** Have a Kohler Engine Service Dealer perform this service.
Table 6-1 Maintenance Chart
Frequency
Maintenance required
Daily or before starting engine
•
Fill fuel tank
•
Check oil level
•
Check air cleaner for dirty, loose, or damaged parts *
•
Check air intake and cooling areas, clean as necessary *
•
Grease cutter shaft bearings.
•
Blow loose dust/dirt off engine
Every 25 Hours
•
Service air cleaner dust cap *
•
Service primary air cleaner element *
Every 50 Hours
•
Clean out cooling fins on engine. If dust is allowed to
accumulate, overheating may occur, causing damage to the
engine.
•
Lubricate frame pivot using multi-purpose grease
Every 100 Hours
•
Change Oil
•
Remove cooling shrouds, and clean as necessary *
•
Check oil cooler fins
•
Check spark plug condition and gap if necessary
•
Lubricate cutter shaft bearings
Every 200 Hours
•
Change oil filter
•
Check secondary air cleaner element and foam wrap *
Annually or every 500 hours
•
Have starter drive serviced **
•
Have solenoid shift starter disassembled and cleaned **
•
Repack wheel bearings.
