Auto (all modes)
: Let the modem decide which network to use.
Auto 3G (3G or less)
: Let the modem decide which 2G or 3G network to use. Do not attempt to connect to LTE.
Force LTE
: Connect to LTE only and do not attempt to connect to 3G or WiMAX.
Force WiMAX
: Connect to WiMAX only and do not attempt to connect tot 3G or LTE.
Force 3G (EVDO, UMTS, HSPA)
: Connect to 3G network only.
Force 2G (1xRTT, EDGE, GPRS)
: Connect to 2G network only.
Network Selection Mode
: Wireless carriers are assigned unique network identifying codes known as PLMN (Public Land Mobile Network). To manually select a particular
carrier, select the Manual radio button and enter the network PLMN. Choose from the following options:
None/No Change
Auto
: Selected by default
Home only
Manual
: Input the PLMN code
Functional Mode
: Selects the functional mode of the modem. IPPT (IP passthrough) mode causes the modem to act as a transport, passing Internet data and IP address
information between the modem and the Internet directly. NAT mode causes the modem to NAT the IP address information. Consequently, IPPT mode does not allow user
access to the modem web UI and NAT mode does allow user access to the modem web UI.
None/No Change
IPPT
NAT
Network-Initiated Alerts
: This field controls whether the Sprint network can disconnect the modem to apply updates, such as for PRL, modem firmware, or configuration
events. These activities do not change any router settings, but the modem connection may be unavailable for periods of time while these updates occur. The modem may also
require a reset after a modem firmware update is complete.
Disabled
: The request to update will be refused.
When Disconnected
: The request to update will only be performed when the modem is either in a disconnected state or dormant state. If the modem is not in
one of these states when the request is received, then the router will remember the request and perform the update when the modem becomes
disconnected/dormant.
On Schedule
: The request to update will only be performed at the specified scheduled time, no matter what the state of the modem is.
Network-Initiated Schedule
: When you select “
On Schedule
” for
Network-Initiated Alerts
, you also select a time from this dropdown list. Modem updates will
take place at this scheduled time.
AT Config Script
: Enter the AT commands to be used for carrier specific modem configuration settings. Each command must be entered on a separate line. The command
and associated response will be logged, so you should check the system log to make sure there were no errors.
NOTE: AT Config Script should not be used unless told to do so by your modem's cellular provider or by a support technician.
AT Dial Script
: Enter the AT commands to be used in establishing a network connection. Each command must be entered on a separate line. All command responses must
include "OK", except the final command response, which must include "CONNECT".
Example:
AT
ATDT*99***2#
WiMAX Settings
WiMAX Realm
: Select from the following dropdown options:
Clear – clearwire-wmx.net
Rover – rover-wmx.net
Sprint 3G/4G – sprintpcs.com
Xohm –xohm.com
CradlePoint COR IBR1100/IBR1150 – Manual
10/13/2014
99
