![background image](http://html.mh-extra.com/html/cpmg/magma-m4/magma-m4_owners-operators-manual_2675062006.webp)
6
Controls and Their Functions
NOTE: This general outline will only familiarize you with the machine. Read through the
entire manual before putting this machine into operation.
1)
Tank Outlet Valve:
Allows melted material from the tank to flow into the pumping sys-
tem.
2)
Access Port:
The sealing wand is placed in here when not in use. This allows operator
to continue circulating material through the hose to prevent material from cooling and
freezing up.
3)
Loading Doors:
Place the material on safety door to load the melting tank.
4)
Micropanel ignition Switch:
Use the key to turn the engine on and off.
5)
Wand Holder:
On models with the electrically heated hose, the wand is placed into
this holder.
6)
Material Temperature Gauge:
Reads material temperature as it pumps through plumb-
ing system.
7)
Pressure Valve:
This valve controls the flow rate of the material being pumped to the
hose and sealing wand by changing the pressure setting. (Turning the valve clockwise
will increase the pressure which in turn will increase the flow). During sealing operations,
this valve alone can be used to regulate flow.
8)
Sealing Hose Valve:
Opening this valve will allow the material being pumped to flow
through the hose and sealing wand. The valve should be in the full "on" position during
operation to prevent flow restriction.
9)
Control Panel:
The main control panel is used to control the direction of the material
pump and agitator, and you can also monitor the temperature of the material and heat
transfer oil.
10)
Pressure Gauge:
This gauge measures the pressure required to turn the agitator. By
observing this gauge, the operator can tell if the agitator is rotating.
11)
Cabinet Temperature Gauge:
Indicates the temperature inside the cabinet. Do not
exceed 320º F (160º C).
12)
Thermal Regulating Gate:
Lift lever to open gate which will direct hot air to cabinet to
heat pump and plumbing.
Summary of Contents for Magma M4
