Enabling Bills and Vend coupons - Continued
Configuration Coupons
Number of Flashes
Meaning
10
The bill or vend coupon has been
enabled successfully
7
The bill validator was unable to read the
bill or vend coupon. Try again.
3
The bill or vend coupon has been
disabled
The unit is pre-configured with the following options enabled:
–
Accept $1 bills
–
Four way accept
Use the included coupon to change the settings:
1. Carefully cut out the coupon
2. Fill out each line using an HB or #2 pencil
Section
Changes
Options
1
Bill Way
Accepted
1 - Face up in one direction (green seal
first)
2 - Face up in either direction
4 - Face up or down in either direction
2
Bills Enabled
On or off to enable or disable a bill
3
Recycled Bill
Can be left blank, but is required for the
recycler
4
Accept
Inhibit
Requires a Recycler
5
Acceptance
Mode
Mode 0: Factory default. No acceptance
modes active.
Mode 1*: If fraud is detected the validator
enters an out-of-service time-out, the stacker
plate extends into the bill magazine and the
bezel LEDs flash. If any sensors are blocked,
the time-out persists until the blockage is
cleared.
Mode 2*: All the features of Mode 1, plus the
stacker plate extends into the bill magazine
when idle.
Mode 3*: All the features of Mode 2, but more
aggressive. It may increase jams and service
calls. Mode 3 is recommended for temporary
use only.
*Requires power
Talos Install Guide_Web_5.24.19.indd 2
5/24/2019 9:57:14 AM
