![background image](http://html.mh-extra.com/html/cpi/oliver-city/oliver-city_owners-manual_2675043026.webp)
Page 26 from 37
The vehicle is equipped each with a lamp for low- and high beam, parking light and additional for stop
light and tail light.
8.3.1 Head light
1. Turn the ignition key to „OFF“ position.
2. Remove the front cover by using a suitable screw driver. Loosen the connector.
3. Take out the bulb and replace it.
ATTENTION – touch bulb exclusively on the socket – it must be free of grease!
4. Assembling in reverse order.
•
At the removal of plastic parts, pay attention that they won’t be scratched.
Additional you have to attend to connection clamps so that they won’t be
damaged. In case of doubt contact one of our authorized dealer.
•
Pay attention to the correct fixing of the bulb to ensure its function. The plastic
ring must snap in and the bulb must be fixed in the correct position.
8.3.2 Front and rear direction indicator
1. Turn the ignition key to „OFF“ position.
2.
Remove the two indicator lens carefully (transparent and orange) by using a suitable screwdriver.
3.
Through lightly pulling, the bulb can be removed.
4.
Assembling in reverse order.
8.3.3 Tail- stop light
1. Remove the taillight housing carefully.
2. Press and turn to the left to take out the bulb.
3.
Assembling in opposite succession.
8.4 CORRECT ADJUSTMENT OF LOW BEAM
The correct adjustment of the low beam is important for your own safety as well for the safety of all other
road users. When buying the vehicle, the head light is already correct adjusted. To check or adjust the
head light you have to consult an authorized dealer. If the normal load conditions of the vehicle change,
the head light adjustment has to be adapted.
8.5 INSPECTION OF CABLE RUBBER PARTS
For protection of the inner cable there are assembled rubber bushings on the cables. Make sure that the
rubber bushing is placed firmly around the cable. When washing the vehicle, do not directly spray water
on the rubber part. Use a dry cloth to clean this area.