![background image](http://html.mh-extra.com/html/cpi/gp8/gp8_operating-instructions-manual_2675037023.webp)
Place the base of the glass against the
front three brushes to dry/polish the top
and bottom of the base. Using the
pinching grip place the glass in the
proper storage vessel.
Turn the unit ’OFF’ and
REPLACE the dust cover.
Once you have completed
drying/polishing all of the
glasses allow the STEMSHINE
to run for a minimum of 10
minutes to fluff up the brushes.
QUICK START OPERATING
PROCEDURES FOR “STEMSHINE” -
THE GLASS POLISHER
www.cpishine.com
T: 866-912-3469
Dust Cover
Power ‘On/Off’
Model GP8A
Press the illuminated
POWER
button to
turn on the machine
.
Wait 10 minutes
to allow the unit to warm up.
Position the unit at waist height on a clean surface -
remove the dust cover.
FOR ULTIMATE RESULTS, GLASS / STEMWARE SHOULD COME FROM YOUR
ON-SITE HIGH TEMPERATURE DISHWASHER -- FRESHLY C WASHED.
Lift the glass and place it on one of
the four outside brushes. Quickly
repeat the rocking action for another
3 to 4 seconds. Finally, pick up the
glass using the “OK” grip and then
pinch the stem of the glass, again
Place the glass over one of the MIDDLE
brushes and gently guide the stem of the
glass. Gently rock the glass back and
forth, side to side, for approximately 3 to 4
Wear the specialized CPI “dimpled”
polishing gloves,
Lift the glass(es) and place on one
of the two middle brushes. Form a
circle with your thumb and fore-
finger and encircle the stem of the
glass – the “OK” grip. This “OK”
grip should only be used to balance
the glass -- the glass should rotate
slightly on the brushes.
DRYING TECHNIQUE
DO NOT APPLY PRESSURE ON THE GLASS OR THE BRUSHES
Summary of Contents for GP8
Page 19: ...Update 07 10 09 Page 20 ...
Page 20: ...Update 07 10 09 Page 21 ...