COX A16916F, Owner'S/Operator'S Manual, Page: 5 / 54

21 October 2021 Page 5
Owners Manual for Model A16916F Hydro Drive
Preparation
While operating, always wear
substantial footwear (not open
sandals) and long trousers.
Thoroughly inspect the area
where the equipment is to be used
and remove all objects which can
be thrown by the machine.
WARNING – Petrol is highly
flammable:
i) Store fuel in containers
specifically designed for this
purpose;
ii) Refuel outdoors only;
iii) Do not smoke while refuelling;
iv) Add fuel before starting the
engine;
v) Never remove the cap of the
fuel tank or add petrol while
the engine is running or when
the engine is hot;
vi) If petrol is spilled, do not
attempt to start the engine but
move the machine away from
the area of spillage and avoid
creating any source of ignition
until petrol vapours have
dissipated;
vii) Replace all fuel tank caps and
container caps securely.
Replace faulty Mufflers.
Before using, always visually
inspect to see that the cutter
assembly, blades, and blade bolts
are not worn or damaged.
Replace worn or damaged
blades and bolts in sets to
preserve balance.
Take care rotating one blade
by hand as this can cause other
blades to rotate.
Operation
Do not operate the engine in a
confined space where dangerous
carbon monoxide fumes can
collect.
Operate the machine only in
daylight or in good artificial light.
Before attempting to start the
engine , disengage Power take off
Clutch and depress clutch/brake
pedal to ensure drive is
disengaged to the transmission.
Do not use on slopes of more
than 15 degrees (1 in 3.75 or
27%).
There is no such thing as a
safe slope.
Travel on grass slopes requires
particular care.
To guard against overturning:
i) Do not stop or start suddenly
when going up or downhill;
ii) Engage hydrostatic drive
slowly;
iii) Always keep hydrostatic drive
operating, especially when
travelling downhill;
iv) Machine speeds should be
kept low on slopes and during
tight turns;
v) Stay alert for humps and
hollows and other hidden
hazards;
vi) Never mow across the face of
the slope.
Use care when pulling loads or
using heavy equipment:
i) Use only approved hitch
points;
ii) Limit loads to those you can
safely control;
iii) Do not turn sharply;
iv) Use care when reversing;
Watch out for traffic when
crossing or near roadways.
Stop the blades rotating before
crossing surfaces other than grass.
When using the mowing
attachment, never direct
discharge of material towards
bystanders nor allow anyone else
near the machine while it is
operating.
Never operate the machine
with defective guards, or
without all safety devices in place
and operating correctly.
Do not change the engine
governor settings or over speed
the engine as excessive engine
speed can increase the risk of
personal injury.
Before leaving the operators
position:
i) Disengage the power take off
clutch:
ii) Set the parking brake in the
locked position.
Disengage drive to
attachments when transporting,
emptying the catcher, or not in
use.
Disengage drive to
attachments and stop engine
before refuelling.
Disengage drive to
attachments, stop engine, and
remove the ignition key:
i) Before leaving the machine
unattended;
ii) Before clearing blockages or
unclogging the chute;
iii) After striking a foreign object.
(Inspect the machine for
damage and make repairs
before restarting or operating
the damaged equipment);
iv) If the machine starts to vibrate
abnormally. (Check
immediately).
Disengage drive to
attachments, stop engine,
remove the ignition key, and
disconnect the spark plug
wires and battery positive lead
before working on, maintaining, or
servicing the machine.
Secure the mowing
attachment in the full up
position:
i) Before clearing blockages or
unclogging the chute;
ii) Before replacing the blades, or
adjusting the tension of the
blade bolts;
iii) Before placing any tools or any
part of your person under the
mowing attachment.
Turn the fuel off using the fuel
shut off valve at the conclusion
of operation.
Maintenance and
Storage
Keep all nuts, bolts and screws
tight to ensure the equipment is
in safe working order.
Replace worn or damaged
parts for safety.
Reduce the fire hazard , by
keeping the engine, muffler,
hydrostatic transaxle, battery
compartment, and petrol storage
area clear of grass, leaves, or
excessive oil and grease.
Also ensure the mowing
attachment drive belt can not
come into contact with grass,
sticks, and leaves built up on the
top surface of the mowing
attachment.
If the fuel tank has to be
drained this should be done out
outdoors.
Never store the machine with
petrol in the tank inside a
building where fumes can reach an
open flame or spark.
Allow the engine to cool before
storing the Ride - on Mower in any
enclosure.
When the machine is to be
parked, stored or left
unattended raise the mowing
attachment and secure it in the full
up position.
GENERAL SAFETY INSTRUCTIONS
CONT.