COVANA Evolution GHSC, Installation Manual

Page: 31 / 56

INSTALLATION MANUAL INSTALLATION 31
18) Install the clip-on barrel nuts at the bottom of the
non-motor-side jack assemblies for the sleeves,
using Phillips M6 x 20 mm screws and 1/4″
washers.
Only the non-motor-side jack
assemblies need clip-on barrel nuts installed.
(Figure 61). Do not fully screw in the M6 screws;
a big gap is needed to slip on the sleeves.
(Figure 62)
19) Insert the jack lock into the back of the M6 screw
without screwing it in. (Figure 62)
Figure 61
M6 screw
Clip-on
barrel nut
1/4
″
Nylon
washer
Figure 62
Gap
Jack lock